|
| Space | Staging | Electricity | | Package 1 Specs | Package 2 Specs | Package 3 Specs | Package 4 Specs | Space:The Basic Sound package requires an empty 6X6 foot space. The Basic Sound and Stage Lighting package can fit into a tight spot; however an empty 6X12 foot space is preferred. The Advanced Lighting packages utilize 2 to 3 six foot pieces of trussing to support the various stage, club and intelligent light fixtures. Generally, we use a 12 to 18 foot truss support system to secure and stabilize the larger lighting packages. The Sound with Stage and Club or Intelligent Lighting packages require an empty 10X20 foot space. If you would like an advanced lighting package in a restricted amount of space, we can make the packages fit into smaller rooms. It will look over crowded, but it can be done. Staging: It is important to us to have a nice vantage point, but staging is not necessarily required for this. However, in a large room, it is nice to be slightly elevated above the crowd. As a central point for announcements and coordination of activities throughout the reception, a slight elevation advantage can allow for ease in crowd direction and control. When a disc jockey/host needs to address and direct your guest to get event activities moving, our delivery is enhanced if we can see a direction and movement. Electricity: First of all, it is nice to be close to a wall plug. Quite often in some reception sites, the location of the disc jockey is not in relation to an electrical outlet. We do carry 25 foot extension cords. If longer cables are needed i.e. 50 or 100 foot, please call and inform our office to make a note on your paperwork. Generally at most new reception sites, electricity has not been a concern. However, at older venues our sound and lighting systems tend to not function well with inadequate power. Low voltage can create electrical surges or spikes within our digital sound and lighting systems that could cause intermittent malfunctions or overloads within the circuitry. Improper electrical grounding can also cause minor problems. Other issues with power have been in connection to the other items on the same circuit in addition to our sound and lighting system. Additional accent lighting, heat lamps and kitchen appliances can cause voltage overload problems. A margarita machine and a coffee maker on the same 15amp circuit will not work. Our equipment and those items will not work together on the same circuit. Margarita machines should be on a dedicated circuit. We also prefer dedicated circuits. A proper distribution of power is important when the need for electricity is great. A simple rule of thumb is to make sure the entertainment is separate from any kitchen devices or additional accent lighting. This should help avoid an embarrassing power outage later in the evening. If electricity may be a concern, contact the reception cite electrician and confirm available power and distribution. Below are the basic specifications for each system. System components will vary depending on the package and accessories. | Space | Staging | Electricity | Package 1 Specifications: This package in a small room requires a single 20 amp plug. In a large room or hall 2 separate 20 or 30 amp plugs will be sufficient. SOUND SYSTEM SPECIFICATIONS OF 1 JBL SPEAKER (2 are used at the average reception site) •Frequency Range (-10 dB): 39 Hz - 18 kHz •Frequency Response (±3 dB): 42 Hz - 17 kHz •Horizontal Coverage (-6 dB): 90° Nominal •Vertical Coverage (-6 dB): 60° Nominal •Rated Maximum SPL 129 dB, @ 1 m (3.3 ft) •LF Driver Integral frame with one 15" (380 mm) driver, dual neodymium magnet, 2" differential drive voice-coil. •HF Driver JBL 2418H-1 1" (throat diameter) compression driver with 1.75" diameter titanium diaphragm. Ferro-fluid cooled. •Amplifier Power LF 300 watts @ low-frequency driver impedance. •Amplifier Power HF 100 watts @ high-frequency driver impedance. •EQ High Frequency Shelving, ±15 dB @ 5 kHz Low Frequency Shelving, ±15 dB @ 120 Hz •AC Input 110 - 230 VAC, 50 - 60 Hz., 175 watts rating per UL, detachable IEC power cable. | Space | Staging | Electricity | Package 2 Specifications: This package in a small room requires two separate 20 or 30 amp plugs. In a large room or hall 3 separate 20 or 30 amp plugs would be suggested. Depending on the available power we use 8 lamps for the average reception and up to 12 lamps for larger rooms. SOUND SYSTEM SPECIFICATIONS OF 1 JBL SPEAKER (2 are used at the average reception site) •Frequency Range (-10 dB): 39 Hz - 18 kHz •Frequency Response (±3 dB): 42 Hz - 17 kHz •Horizontal Coverage (-6 dB): 90° Nominal •Vertical Coverage (-6 dB): 60° Nominal •Rated Maximum SPL 129 dB, @ 1 m (3.3 ft) •LF Driver Integral frame with one 15" (380 mm) driver, dual neodymium magnet, 2" differential drive voice-coil. •HF Driver JBL 2418H-1 1" (throat diameter) compression driver with 1.75" diameter titanium diaphragm. Ferro-fluid cooled. •Amplifier Power LF 300 watts @ low-frequency driver impedance. •Amplifier Power HF 100 watts @ high-frequency driver impedance. •EQ High Frequency Shelving, ±15 dB @ 5 kHz Low Frequency Shelving, ±15 dB @ 120 Hz •AC Input 110 - 230 VAC, 50 - 60 Hz., 175 watts rating per UL, detachable IEC power cable. STAGE LIGHT SYSTEM SPECIFICATIONS 1 BAR NSI DDS 5600 4 Channels @ 300 watts (2 are used at the average reception site) •Model 20 amp •Total Capacity 2400 watts •Lamp Par 56 300 watt | Space | Staging | Electricity | Package 3 Specifications: This package in a small room requires 3 separate 30 amp plugs. In a large room or hall 4 separate 30 amp plugs would be suggested. Depending on the stage, club and intelligent light combinations, special electrical outlet requirements are necessary. SOUND SYSTEM SPECIFICATIONS OF 1 JBL SPEAKER (2 are used at the average reception site, 4 speakers can be used for surround sound) •Frequency Range (-10 dB): 39 Hz - 18 kHz •Frequency Response (±3 dB): 42 Hz - 17 kHz •Horizontal Coverage (-6 dB): 90° Nominal •Vertical Coverage (-6 dB): 60° Nominal •Rated Maximum SPL 129 dB, @ 1 m (3.3 ft) •LF Driver Integral frame with one 15" (380 mm) driver, dual neodymium magnet, 2" differential drive voice-coil. •HF Driver JBL 2418H-1 1" (throat diameter) compression driver with 1.75" diameter titanium diaphragm. Ferro-fluid cooled. •Amplifier Power LF 300 watts @ low-frequency driver impedance. •Amplifier Power HF 100 watts @ high-frequency driver impedance. •EQ High Frequency Shelving, ±15 dB @ 5 kHz Low Frequency Shelving, ±15 dB @ 120 Hz •AC Input 110 - 230 VAC, 50 - 60 Hz., 175 watts rating per UL, detachable IEC power cable. STAGE LIGHT SYSTEM SPECIFICATIONS 1 BAR NSI DDS 5600 4 Channels @ 300 watts (2 are used at the average reception site) •Model 20 amp •Total Capacity 2400 watts •Lamp Par 56 300 watt CLUB LIGHT SYSTEM SPECIFICATIONS Electra Multi-Colored moonflower (2 are available) •Fuse / Voltage 3a / 110v - 120v •Total Capacity 50 watts •Lamp ZB-BRL 12V 50W Y2L Millennium 40 Beam 7 dichroic colors (2 are available) •Fuse / Voltage 10a / 120v •Total Capacity 600 watts •Lamp 2x ZB-64514 120V, 300W Kamala 80 Beam 12 dichroic colors (2 are available) •Fuse / Voltage 15a / 120v •Total Capacity 900 watts •Lamp 3x ZB-64514 120V, 300W | Space | Staging | Electricity | Package 4 Specifications: This package in a small room requires 3 separate 30 amp plugs. In a large room or hall 4 separate 30 amp plugs would be suggested. Depending on the stage, club and intelligent light combinations, special electrical outlet requirements are necessary. SOUND SYSTEM SPECIFICATIONS OF 1 JBL SPEAKER (2 are used at the average reception site, 4 speakers can be used for surround sound) •Frequency Range (-10 dB): 39 Hz - 18 kHz •Frequency Response (±3 dB): 42 Hz - 17 kHz •Horizontal Coverage (-6 dB): 90° Nominal •Vertical Coverage (-6 dB): 60° Nominal •Rated Maximum SPL 129 dB, @ 1 m (3.3 ft) •LF Driver Integral frame with one 15" (380 mm) driver, dual neodymium magnet, 2" differential drive voice-coil. •HF Driver JBL 2418H-1 1" (throat diameter) compression driver with 1.75" diameter titanium diaphragm. Ferro-fluid cooled. •Amplifier Power LF 300 watts @ low-frequency driver impedance. •Amplifier Power HF 100 watts @ high-frequency driver impedance. •EQ High Frequency Shelving, ±15 dB @ 5 kHz Low Frequency Shelving, ±15 dB @ 120 Hz •AC Input 110 - 230 VAC, 50 - 60 Hz., 175 watts rating per UL, detachable IEC power cable. STAGE LIGHT SYSTEM SPECIFICATIONS 1 BAR NSI DDS 5600 4 Channels @ 300 watts (2 are used at the average reception site) •Model 20 amp •Total Capacity 2400 watts •Lamp Par 56 300 watt CLUB LIGHT SYSTEM SPECIFICATIONS Electra Multi-Colored moonflower (2 are available) •Fuse / Voltage 3a / 110v - 120v •Total Capacity 50 watts •Lamp ZB-BRL 12V 50W Y2L Millennium 40 Beam 7 dichroic colors (2 are available) •Fuse / Voltage 10a / 120v •Total Capacity 600 watts •Lamp 2x ZB-64514 120V, 300W Kamala 80 Beam 12 dichroic colors (2 are available) •Fuse / Voltage 15a / 120v •Total Capacity 900 watts •Lamp 3x ZB-64514 120V, 300W INTELLIGENT LIGHT SYSTEM SPECIFICATIONS Pocket Scan DMX intelligent scanner (5 are available) • Built-in 5m laser • 15 colors plus white • 14 gobos • Separate color and gobo wheel • Lamp: 12v/100w JCR 1500 hour lamp life ScanTron DMX intelligent scanner (4 are available) • 2-in-1 intelligent lighting effect that converts from a scanner to a color changer with gobos: unique design with removable X-Y mirror head • 14 gobos plus spot • 11 colors plus white • Extruded aluminum case design • 5-channel DMX protocol • Linkable via XLR connections • Smooth stepper motors • Dual hanging brackets • Fan cooled • EZ Lamp replacement door • Sound actived with sensitivity knob • Manual full-focusing lens • ZB-ELC 24V, 250W • Dimensions: 5.75 x 10.25 x 20.75 (LxWxH) • Weight: 23 lbs High End Track Spot (4 are available) •Color wheel features 8 colors, including 1 CTB color corrector, and 1 open position •Gobo wheel has 8 etched positions and 1 replaceable position •Variable strobe •Electronic circuit design for 100% dimming •Built-in condenser microphone for sound-to-light •High resolution micro-stepping motor control for smooth motion at all speeds •Computer designed optical components for maximum light efficiency •170° pan and 110° tilt movement •Control Options: DMX-512; LWR protocol •Operates on 7 DMX channels •Power Consumption: 350W; 100V - 240V, 50/60 Hz | Space | Staging | Electricity | |